Kenmore Dryer Error Code: F28 & F29

Your trusty Kenmore dryer is humming along when suddenly, you’re faced with perplexing error codes, F28 and F29. These codes indicate a problem with the moisture sensor. Before you start to panic, this article will guide you through understanding, diagnosing, and resolving these issues, ensuring your laundry routine gets back on track.

Understanding Kenmore Dryer Error Codes F28 and F29

Error codes F28 and F29 on your Kenmore dryer are typically associated with moisture sensor failures. These sensors play a crucial role in ensuring your laundry dries efficiently while preventing over-drying, which can lead to damaged clothes and wasted energy. When these error codes appear, it’s a sign that something is amiss with the moisture sensor system.

Diagnosing the Issue

1. Power Down the Dryer: The first step is to power down your Kenmore dryer and unplug it from the electrical source. Safety always comes first.
2. Visual Inspection: Visually inspect the wiring harness connected to the moisture sensor. Look for loose, damaged, or disconnected wires. Moisture sensors are often located near the front of the dryer drum.
3. Multimeter Test: If a visual inspection doesn’t reveal the issue, it’s time to bring out a multimeter. Set it to measure resistance and carefully test the moisture sensor’s wiring. The sensor should have a consistent and measurable resistance. A significant deviation from the expected resistance could indicate a problem.

Resolving the Issue

If your diagnostic efforts confirm that the moisture sensor is indeed the culprit, it’s time to consider replacement.

Replacing the Moisture Sensor

1. Order the Replacement Sensor: Start by identifying the model of your Kenmore dryer to ensure you order the correct replacement moisture sensor.
2. Unplug the Dryer: Always unplug the dryer from the electrical source to ensure your safety during the replacement process.
3. Access the Sensor: Typically, moisture sensors are located near the front of the drum. You may need to remove the front or rear panel, depending on your dryer’s model, to access the sensor.
4. Remove and Replace: Carefully disconnect the wiring harness from the old moisture sensor. Then, remove the sensor itself. Replace it with the new one and reconnect the wiring harness.
5. Reassemble: Reassemble any panels or covers you had to remove to access the sensor.
6. Power Up: Plug your dryer back in and power it up. Run a test cycle to ensure the error codes F28 and F29 are gone.

By following these steps, you can efficiently address moisture sensor issues indicated by Kenmore dryer error codes F28 and F29. However, if you find these troubleshooting steps challenging or if the problem persists, don’t hesitate to contact professional appliance repair technicians. They have the expertise to handle complex issues and ensure your Kenmore dryer works flawlessly.